NIDEC COMPONENTS logo
NIDEC COMPONENTS logo

LIST

×

×


Products

Distributor

SG-English

×

Tactile switch TME1

●To buy this product, please go to the following Online Web stores.
To the Tactile switch“TME1 series” page on the RS Components online shop
To the Tactile switch“TME1 series” page on the Chip1stop online shop

Tactile Switches

 
FeaturesFeatures
  • Compatible With Lead-Free Soldering
    Heat-resistance resin for lead-free soldering.
  • Washable
  • 2.54 mm Terminal Pins
  • Compatible with Automatic IC Insertion Machine
    (Stick packaging, 50 pcs/stick)
  • 180° Symmetric Terminal Pin Layout.
  • Anti-Static Electricity
    Ground terminal is provided to prevent damage to element caused by static electricity.
  • Metal contact for sharp tactile feel.
◆Structure

Specifications

Rating Max. 1VA max.( 50mA max.48VDC max.)
Initial contact resistance 100m Ω max. {1.5mA 200μVAC at 1.96N{200gf}force}
Dielectric strength 250VAC 1 minute
Insulation resistance 100MΩ min. (100VDC)
Electrical life 1,000,000 operations
Stroke 0.5±0.3mm
Operating force 1.96±0.98N
Oepmepraetriantgu re range -25~+70℃
Setmorpaegrea ture range -40~+70℃

Part Number Designation

TMEG1-01 -Z

Series

Contact plating

Blank: Silver plated
G:Gold plated

Structure

Registration No.

 

List of Part Numbers

 

 

 
 
 Part numberContact platingSwitching functionCAD
Part No.:TME1-01-Z Silver plated OFF-(ON)

Outline dimensions

Circuit diagrams

PC Hole Layouts

  •   The blue line shows the outline of the switch.
  • Terminal (E) to be connected to Ground. Terminal (E) is connected to the metal frame.

Soldering Specifications

  • Manual Soldering
    Device : Soldering iron
    380°C ±10°C; 3±0.5 seconds
  • Auto Soldering
    Device:Jet wave type or dip type
    275°C; 6 seconds, Max.
    ・Preheating should be at 80°C to 120°C, max., within 120 seconds.
  • When soldering two or more terminals to the common land, use solder resist to solder them independently.

Flux Cleaning

  • Solvent: Fluorine or Alcohol type Cleaning with other solvents or water is not possible.
  • Cleaning after soldering should be done after the terminal temperature falls to 90°C or below, or after leaving the switch for five minutes or longer at room temperature. Cleaning temperature: 43°C, max.
  • Do not use ultrasonic cleaning.

Environmental Data

●The above contents and descriptions are subject to change without notice. 

Products

×

page top